electrical bike Bike Verify: Alexis Cheneviers Trans-Vesubienne Yeti SB100
In a current interview, he admitted that he would like to attempt the BC Bike Race, however does not have the assist to race internationally. That is the opposite factor that makes him so spectacular – there isn’t any cash chasing these races, no media protection, no parade down the Champs Elysee. He does it just because he loves it. Over the previous few years, he has smashed quite a lot of full-time athletes, all of the whereas holding down a job as a wheel engineer at Mavic, or not less than he was till lately as he has fallen casualty to the turbulent times at the legendary French brand a month in the past and is at the moment on the lookout for a brand new job. We caught up with him simply earlier than he took on the Trans Vesubienne to see how he units up his race bike for this type of problem because it definitely is not your customary XC race bike.
Top 5’8″ / 173cm
Weight 143 lb / 65kg
Hometown Annecy, France
Mannequin Yeti SB100
Body Dimension Medium
Wheel Dimension 29
Suspension Fox 34 Stepcast and Float DPS
Drivetrain & Brakes SRAM XX1 & Shimano XT
Tyre pressures 1.6 + 1.8bar / 23 + 26psi
Tokens 2 tokens
Mavic weren’t simply his employer, but in addition his sponsor – he’s operating a pre-production set of carbon Crossmax SLR wheels with a 25mm inner width rim.
With no sponsor for his drivetrain and brakes he runs workhorse Shimano XTs, however with Brake Authority pads and discs (180mm entrance, 160mm rear).
The one a part of his drivetrain he’s supported for is the crank – a Raceface Subsequent SL to maintain the burden down. For this race, he ran a 30t chainring paired to a normal 10-50t Eagle XX1 cassette on the again. The non-driveside of the crank and each bar ends are filled with tyre plugs as light-weight tyres on these trails have a nasty behavior of selecting up punctures, which have determined the race on a couple of event.
He runs a Raceface cockpit, with a low-rise Subsequent SL bar, trimmed right down to 750mm and a 60mm stem – not your customary XC racing setup, even when the stem is flipped to maintain the stack top down. Whereas he does not measure every aspect of the cockpit he’s very explicit about their place and it normally takes him just a few rides with a brand new bike to get them in simply the appropriate place. The saddle is a minimal Selle Italia X-LR, perched atop a 150mm drop Fox Switch publish. In a considerably uncommon transfer, he runs the shock distant on the right-hand aspect of his bars.